Skip to main content
Beantwoord

Use WX5600 as a standalone access point

  • 17 december 2024
  • 1 reactie
  • 113 Bekeken

  • heeft eerste post geplaatst
  • 2 reacties

Hi, can I use WX5600 as a standalone access point, without connecting it to controller (EX7501)?
When I put WX5600 to my network by wire, it automatically became as a mesh device for the main router EX7501, it clones its WIFI settings, and refuses to change it.
If I reset WX5600 and don't connect it with a wire to EX7501, it is unable to put manual settings to it, it says that there is no controller, and sorry, I will not work.

But for some reason I want to configure it separately, with own SSID, and use another subnet.
Is there a way to do this? Maybe there is an appropriate firmware for such purposes?

Beste antwoord door Tommie van Odido

Hi ​@wf1nder, welcome to our Community!

It is not possible to use the WX5600 as a standalone access point on a different subnet. Our Wifi points only work through the mesh network on the Zyxels. 

Bekijk origineel

1 reactie

Tommie van Odido
Moderator
Forum|alt.badge.img+11
  • Moderator | Internet + TV
  • 13993 reacties
  • Antwoord
  • 18 december 2024

Hi ​@wf1nder, welcome to our Community!

It is not possible to use the WX5600 as a standalone access point on a different subnet. Our Wifi points only work through the mesh network on the Zyxels. 


Reageer


Cookiebeleid

Wij gebruiken cookies om uw bezoekers ervaring te verbeteren en te personaliseren. Ga je akkoord, of ga je door op de website dan ga je akkoord met ons cookiebeleid. Meer informatie.

 
Cookie instellingen